Vaporflask clone 40w TC box mod – $46.70

If you don’t have enough money, this is one version clone of the Vapor Flask. This box mod houses 2 x 18650 removable batteries. This 40 watt box mod uses a dna 40 clone with temperature control. This device can read atomizers as low as 0.16 ohm in variable wattage mode. The Vaporflask clone features a 0.69 inches OLED screen. If you want to buy this very nice regulated box mod, pick up one at Focalecig for only $46.70 with free shipping. The Vapor Flask dna 40 clone will be a great choice for most vapers.

Vapor Flask 40 watt temperature control box mod with dual 18650 batteries

Best Deals for VaporFlask clone

Get this deal
Vapor Flask clone dna 40 - $46.70

Worldwide Free shipping.

Vapor Flask clone Review

Powered by Evolv DNA 40, Vapor Flask is a remarkable Advanced Personal Vaporizer. Its curved design enables the user to easily grasp the mod in their hand, which makes vaping convenient. It has an ergonomic design and four vent holes on each battery cover.

The major selling point of the Vapor Flask clone is the Evolv DNA 40 chip, which is widely regarded in the vaping community as one of the best processors available today. This chip permits the DNA 40 clone to be charged via Zipping Charging Technology, which reduces charging time significantly. Not only that, but the battery also lasts longer. Thus, after charging the mod for about an hour, users can enjoy long vaping sessions without ever having to worry about the batteries dying.

The Vapor Flask clone DNA 40 also boasts an efficient temperature control system that allows vapers to adjust the temperature of the atomizer coil. This feature allows the user to control the temperature of the coil according to their preference of warm or cold hits.

The Vapor Flask Squonk clone has a wattage output of 40 watts, and a voltage output of 9 volts. Even though some potential clients might be put off by the 40-watt wattage output, they should understand that a mod is only as good as its build quality and temperature control. Another point to remember is that 40 watts is sufficient for 600F vaping which is, temperature-wise, generally the maximum amount that people vape.

Vapor Shark was quite smart in choosing to power this mod with two external 18650 batteries (sold separately) instead of a single internal one. Thus, when the battery fails, you can simply replace them instead of having to replace the entire mod, making it more economical. These batteries can be charged by using a microUSB charger, which is easily available in the market.

Vapor Flask clone video review

Vapor Flask clone Specs & Features

  • Built in aluminium,
  • Connexion thread : 510,
  • Output wattage : 1 – 40 watt,
  • Output voltage : 1 – 9 volt,
  • Temperature control : 200 – 600°F,
  • Atomizer Ohm capability in VW mode : 0.16 – 2 Ohm,
  • Atomizer Ohm capability in TC mode : 0.10 – 1 Ohm,
  • Type of wires : Kanthal, Ni200,
  • Battery : 2 x 18650,
  • Dimensions : 9.2 x 6.0 x 2.9 cm,
  • Weight : 200 grams.

Last Vape deals

17% OFF at

Coupon Codes

15% OFF at

Coupon Codes

I am an enthusiast vaper since 2011. Every day, I try to find the best vape deals around the world. With free shipping of course !